10 | CLARO
CHARGING THE BATTERY
Your CLARO comes with a partial initial charge from the manufacturer
but it is recommended to fully charge the unit before full treatment.
Initial Charging. Before your rst use, charge CLARO for 12 hours. If you
do not use your CLARO for 3+ months, periodically charge for 6 Hours
to maintain the battery life. When battery is low, the light will ash red 3
times then auto shut o. Do not use CLARO while charging.
Turn on the Power Button and check the Indicator (green) light. The light
will be blinking if the battery needs to be charged. A steady green light
means the battery is charged and the device is ready to use.
If the battery needs charging, plug the CLARO into that USB Cord and
insert the opposite end of the cord into a wall adapter or computer USB
port. The Power Indicator Light will remain lit while charging is in process
and will turn o when the battery is fully charged. Unplug the device and
USB Cord when nished.
CAUTIONS:
• Always attach the USB Cord to the CLARO rst before
inserting into an outlet.
• Charge the battery only when needed (when the Power
Indicator Light starts blinking). Premature charging of the
battery can cause the Power sensor to malfunction.
• The CLARO cannot be used while charging.
To Next Page
Loading...
