CLARO | 11
CONTROLS
The CLARO is simple to use.
• The ON/OFF button turns on the device.
• The power light over the ON/OFF button indicates when the
device is ON (steady green light) or when the battery needs
charging, the light will ash red 3 times.
• The device will only emit light when the treatment head is
in contact with your skin. This is a safety feature to reduce
the likelihood of light shining in the eyes and also prolongs
the life of the CLARO because the light is only on when
delivering treatment.
• When the device is on, but not in contact with the skin, it is
in STANDBY mode. The device automatically turns o if not
used after 3 minutes in STANDBY mode.
• CLARO comes with a buit-in reminder that will beep once
every 3 minutes so you move to another treatment area.
• After 3 minutes of treatment use (in contact with skin), 1
beep will sound. Move the treatment head to a new area
for another 3 minute treatment cycle. The device will
automatically shut o after 12 minutes (4 treatment cycles of
3 minutes).
To Next Page
Loading...
