SpacePak ESP-J - Defaults

29
The following menu trees are accessible within the advanced control. They can be accessed by holding the "ESC" key
down for 3 seconds. Within these menu trees are configurable settings for each application and unit type. Please refer
to the proper menu tree per the firmware version on the control board prior to making any changes or adjustments to
the unit configuration. Failure to do so can prevent proper operation and performance of the system. The defaults
menu is how each unit is configured from the factory. By using the menu trees, these defaults can be adjusted.
*The unit model and size will be set from the factory specific to that unit. If it is a replacement
board, the default model will be "ESP" and the default size will be 2430JH. Please properly
commission all replacement boards specific to that application
ITEM DESRIPTION
DEFAULT
MAX
MIN
UNIT MODEL*
PER UNIT PURCHASED
UNIT SIZE*
PER UNIT PURCHASED
UNIT TYPE
HP
REVERSING VALVE
O
SEC HW COIL
NO
AUX 1
HEAT
FAN
CONSTANT PRESSURE
ANTI FROST TEMPERATURE
34
50°F
34°F
SPEED Y1
50%
100%
5%
SPEED Y2
50%
100%
5%
SPEED Y12
50%
100%
5%
SPEED W1
50%
100%
5%
SPEED W2
50%
100%
5%
SPEED W12
50%
100%
5%
SPEED G
50%
100%
5%
SPEED HUMIDIFIER
50%
100%
5%
SPEED ERV
50%
100%
5%
SPEED DEFROST [DFS]
30%
100%
5%
STATIC PRESSURE Y1
1.2 "WC
2.5 "WC
0.5 "WC
STATIC PRESSURE Y2
1.2 "WC
2.5 "WC
0.5 "WC
STATIC PRESSURE Y12
1.2 "WC
2.5 "WC
0.5 "WC
STATIC PRESSURE W1
1.2 "WC
2.5 "WC
0.5 "WC
STATIC PRESSURE W2
1.2 "WC
2.5 "WC
0.5 "WC
STATIC PRESSURE W12
1.2 "WC
2.5 "WC
0.5 "WC
STATIC PRESSURE G
1.2 "WC
2.5 "WC
0.5 "WC
STATIC PRESSURE HUMIDIFIER
1.2 "WC
2.5 "WC
0.5 "WC
STATIC PRESSURE ERV
1.2 "WC
2.5 "WC
0.5 "WC
STATIC PRESSURE DEFROST [DFS]
0.7 "WC
2.5 "WC
0.5 "WC
HEATING START TEMPERATURE
80
120°F
60°F
COOLING START TEMPERATURE
70
80°F
50°F
FAN ON DELAY
2 MINUTES
5 MIN
1 MIN
FAN OFF DELAY
1 MINUTES
5 MIN
0 MIN
DEFAULTS