Page 10 Seaich Corporation, LLC. All rights reserved. www.seaich.com
|
Spacerails, LLC. www.spacerails.com
Step2: Continue from arm-D-2 down and attach next at arm C-1 and loop up to
arm B-1 creating a 10 cm loop. Exit loop past Arm B and attach at arm A-1 extend
rail beyond base to create a banked turn and attach at arm A-2. Next attach arm
C-2, E-1, and back to arm D-1. Finish at the Rail Clip on the lower right elevator
entrance. Repeat step for second rail.
Fine Tune: Once each rail section is completed run a Marble
down your course and make sure it travels well.
Rail Section 1:
To Next Page
Loading...
