Spacerails Level 2 - Page 11

Seaich Corporation, LLC. All rights reserved. www.seaich.com
|
Spacerails, LLC. www.spacerails.com Page 11
B
INSTALLING RAIL
Rail Section 2:
Step1: Starting at the top Elevator Ring on the right
side Rail Clip connect rail B (105 cm). Connect through
arm E-3 then around to arm D-3, B-2, and A-5. Repeat
for second rail. The end of this section drops the Marble
onto the See-Saw section.
Step2: The last See-Saw Arm will drop the Marble
on the exit section. To construct use rail C (26 cm)
and start connecting at arm A-3 and pass through
armC-3 entering the left facing Rail Clip on the second
Elevator Ring. Repeat for second rail.
NOTE:
Congratulations on completing Spacerails Level 2! Fine tune the rails and see how many marbles you can get going
at the same time. If the marbles are coming into the elevator too quickly it may knock other marbles already in the
tower out. Create a dip or nd other ways to slow marbles to just the right speed at entrance.