Page 7
Uncrating and Prep
4.) Next you’ll want to plan out the exhaust routing and the
frame mounting points. If required, use the flexible exhaust
pipe (cut to length) and elbow supplied with this unit. Be
sure to avoid any brake and fuel lines, fuel tank, spare tire
mounts, etc. Once the desired position is achieved, mark
the hole locations for the exhaust port and the frame mounts.
(See Fig. 1)
5.) Using the skid mount frame holes as a guide, drill (8)
13/32 diameter holes through the floor of the vehicle.
6.) Place the (8) rubber pads between the frame and the
vehicle floor and then secure the skid mount unit to the vehicle
using the (8) 3/8-16 x 3” screws, (16) 3/8 flat washers, and
(8) 3/8-16 locking nuts.
7.) Cut or drill an opening in the vehicle floor and mount the
exhaust port. Use the supplied muffler clamps to secure the
flexible pipe and elbow to the muffler.
8.) Remove the battery cover and connect the positive cable
(red) to the positive post of the battery. Replace cover.
9.) Connect the fill hose and bypass hose to the water tank.
No clamps required (See Fig. 2)
10.) Connect the water tank to the pump using the supply
hose (short hose included with unit) and (2) hose clamps
(included with unit) (See Fig. 3 on next page)
11.) Connect the low water switch. (See Fig. 4 on next
page)
pp
pp
p
!
Fig. 1
Fig. 2
If you received your machine crated, follow the steps below.
1.) Remove the 8 bolts that secure the jetter frame and the water tank frame to the crate.
2.) Position the unit inside your van or truck bed in a location that best fits your application.
3.) Secure the two units together by using the included (2) 3/8-16 x 4-1/2” screws, (4) 3/8 flat washers,
and (2) 3/8-16 locking nuts.
To Next Page
Loading...
