SHARPENING NEW STEEL
To watch the How-To video, visit sparxhockey.com/newsteel.
Before loading new steel, try taking a dark colored
marker and running it down the bottom surface of the
skate blade. To ensure you have sharpened the entire
blade, inspect the blade after running the cycles and
if the sharpening is complete, all of the marker on the
skating surface will be removed.
1 LOAD THE SKATE
Follow the instructions in “Loading a Skate” in the Operation
section of this manual.
2 ADJUST GRINDING RING HEIGHT
Follow the instructions in “Adjust the Grinding Ring Height” in
the Operation section of this manual.
3 SELECT 1 CYCLES
Using the
l
Left and
r
Right Buttons, select
1
on the
Cycle Counter.
4 CONTINUE THE SHARPENING PROCESS
Refer to the Operation section of the manual.
Below is how an installed Youth Skate Adapter will look.
2 CONTINUE THE SHARPENING PROCESS
Refer to ”Load the Skate” in the Operation section of
the manual.
3 REMOVE YOUTH SKATE ADAPTERS
Press up on the lip (A) of the Youth Skate Adapter until it clicks
out from the Protective Slot Cover Switch (B).
A
B
To Next Page
Loading...