Sparx Skate Sharpener - MAINTENANCE; REMOVING AND EMPTYING THE DUST TRAY; REPLACING THE AIR FILTER

To Next Page

To Previous Page

There are no user-repairable parts in the Sparx™

Sharpener. Refer to “Exclusions” in the Warranty

section for more information. Maintenance of the

Sparx™ Sharpener is limited to the procedures outlined

in this section.

REMOVING AND EMPTYING

THE DUST TRAY

To watch the How-To video, visit sparxhockey.com/dusttray.

Maintenance Frequency: Perform the following steps after every ½

Grinding Ring of sharpener use (160 cycles on any of the following:

Radius Ring™, FIRE Ring™, or X-Grind Ring) and before moving and/

or traveling with the sharpener.

1 REMOVE AND EMPTY THE DUST TRAY

Open the Glass Door and remove the Dust Tray. To empty Dust

Tray—wipe completely clean with a damp cloth (water).

Do not use any solvents or cleaning chemicals in and

around the Skate Sharpener.

2 VACUUM SHARPENER

Without removing the Air Filter, thoroughly vacuum the top, sides,

and around the Air Filter Housing. We recommend using a HEPA

certiﬁed vacuum.

3 REPLACE THE DUST TRAY

Slide the Dust Tray back into the machine. Close the

Glass Door.

REPLACING THE AIR FILTER

To order a replacement Air Filter, visit sparxhockey.com/ﬁlter.

To watch the How-To video, visit sparxhockey.com/airﬁlter.

Standard Grinding Ring Use (Radius Rings™ and FIRE Rings™): The

Air Filter should be replaced every 4 Grinding Rings (1, 280 cycles).

Sparx X-Grind Ring Use: the Air Filter should be replaced every 2

Grinding Rings (640 cycles).

Maintenance Frequency: The Air Filter replacement limits listed

above are related to the type of Grinding Rings being used and refer

to the maximum amount of usage that an Air Filter should have

when using a speciﬁc type of Grinding Ring.

The

Air Filter Button will light up to remind you to replace the

Air Filter at the Standard Grinding Ring Use interval ONLY (X-Grind

Ring Must be Accounted for Separately by the User).