Sparx Skate Sharpener - Page 15

shown below. Release the Clamp Lever. Ensure that the
middle section of the Travel Guard (A) is held securely in
the Skate Clamp.
5 REMOVE THE CLAMP LEVER
Slide the Clamp Lever (A) o of the Lever Dock.
When setting up the Sparx Sharpener after travel,
wipe down the Grinding Ring Shaft’s face and
threaded arbor to remove any unwanted steel
shavings that may have gathered during transit. This
will ensure a proper fit between the Grinding Ring
Shaft and the Grinding Ring.
A
A