10
Maintenance
We recommend any service be performed by a qualified bicycle mechanic. To obtain
service information or instructions, visit our website at www.sram.com or contact your local
RockShox dealer or distributor.
Take your bicycle to a qualified dealer for inspection and repair if there is any question of
component integrity due to a crash or other direct impact.
WARNING
Before disassembly or service of any air system remove the air pressure from all air
chambers. For complete service instructions visit www.sram.com/service.
To maintain the high performance, safety, and long life of your front suspension, it is required
that you periodically check the fastener torque values for compliance as well as perform
routine maintenance on your fork. If you ride in extreme conditions, torque compliance
checks and maintenance should be performed more frequently.
FRONT SUSPENSION FASTENER TORQUE VALUE
Top Caps
13.6 N•m (120 in-lb) Non-drive side
28.2 N•m (250 in-lb) drive side
Bottom Bolt 7.3 N•m (65 in-lb)
Disc Brake Mounting Bolts 10.2 N•m (90 in-lb)
MAINTENANCE INTERVAL (hours)
Clean dirt and debris from upper tubes Every ride
Check air pressure (air forks only) Every ride
Inspect upper tubes for scratches Every ride
Lubricate dust seals and upper tubes Every ride
Check front suspension fasteners for proper torque 25
Remove lowers, clean/inspect bushings and change
oil bath
50
Clean and lubricate air spring assembly 100
Change oil in damping system (including hydraulic
lockout)
100
To Next Page
Loading...
