To Next Page

To Previous Page

USER MANUAL

4.1.2 Network Configuration

If you connect to a router that allows the use of DHCP, please check the

DHCP

box. The router will

automatically assign all the network parameters for your WIRELESS NVR. Below are the

parameters to complete if the network does not use DHCP:

IP Address

: The IP address identifies the WIRELESS NVR on the network. It consists of four

groups of numbers between 0 to 255, separated by periods. For example, “192.168.1.100”.

Subnet Mask

: Subnet mask is a network parameter which defines a range of IP addresses that

can be used in a network. If the IP address is like a street where you live, then subnet mask is like

a neighborhood. The subnet address also consists of four groups of numbers, separated by

periods. For example, “255.255.0.0”.

Gateway

: This address allows the WIRELESS NVR to access the Internet. The format of the

Gateway

address is the same as the

IP Address

. For example, “192.168.1.1”.

DNS1/DNS2

: DNS1 is the primary DNS server and DNS2 is a backup DNS server. It’s usually

adequate to just enter the DNS1 server address.

Speco ZIPK8WN2 User Manual

Questions and Answers: