USER MANUAL
26
5.1.3 Motion
This menu allows you to configure motion parameters. When motion has been detected
by one or more cameras, your WIRELESS NVR will alert you to a potential threat at your home. It
does this by sending you an email alert with an attached image from the camera to use as a
reference (if this option is enabled) and/or sending push notifications via the mobile app.
Setup
: Click icon into the setup page.
Switch
: Enable or disable motion detection.
Sensitivity
: Set the sensitivity level. Level 1 is the lowest
sensitivity level while level 8 is the highest sensitivity level.
Motion Detection Area:
The whole screen is marked for motion
detection (red blocks) as default. If you
want to disable the motion detection on a
certain area, click the grid cursor and
then drag the mouse to highlight the
scope to unmark the area into
transparent blocks. After setting is
completed, click the right button of your
mouse to return and click Save to make
the area setup effective.
To Next Page
Loading...
Need help?
General