USER MANUAL
4
Chapter 1 Safety Instructions
Please carefully read the following safety instructions so as to avoid personal injuries and
prevent the equipment and other connected devices from being damaged.
1. Power sources (note: please use the power supply attached or included in the box)
Never operate the equipment by using an unspecified power supply.
2. Never push objects of any kind through the openings on WIRELESS NVR
Never push objects of any kind through openings on WIRELESS NVR so as to avoid
electric shock or other accidents.
3. Do not install the equipment in a dusty area
Do not install the equipment in a dusty area.
4. Do not place the equipment outdoors or in a humid environment
Do not place the equipment in a humid environment like a basement. If the equipment is
accidentally in contact with water, please unplug the power cable and immediately contact
your local dealer.
5. Keep the surface of the equipment clean and dry
Use a soft damp cloth to clean the outer case of your WIRELESS NVR (do not use liquid
aerosol cleaners)
6. Do not operate if any problems are found
If there are any strange smells or sounds from your WIRELESS NVR, unplug the power
cable and contact your authorized dealer.
7. Do not try to open the unit
Warning: Do not remove the cap of WIRELESS NVR so as to avoid electric shock.
8. Handle with care
If your WIRELESS NVR does not work normally because of contact with the floor or a
hard object, please contact your authorized dealer for repair or replacement.
9. Install the unit in a place with good ventilation
The WIRELESS NVR system includes a hard drive which produces large amounts of heat
during operation. As a result, do not block the ventilation openings (on the top, bottom,
To Next Page
Loading...
Need help?
General