USER MANUAL
28
5.1.5 Alarm
Click
Alarm
button to configure the motion detection alarm function:
Channel:
Display channel number.
Buzzer:
The WIRELESS NVR can use its internal buzzer to emit an alarm tone. You can set the
buzzer duration in seconds when the motion is detected.
Record
: Click icon and choose which channel(s) you want to record when the motion
detection is triggered.
Post Recording
: You can set how long after an event occurs that the WIRELESS NVR will
continue to record. The recommended recording length is 30 seconds but it can be set higher up
to 5 minutes.
Show Message
: Check the box to display
icon on the live view screen when the motion is
detected.
Send Email
: You can let the WIRELESS NVR to send you an auto-email when the motion is
detected.
Full Screen
: If this function is enabled and a motion is detected in a channel, you will see that
channel in full screen.
To Previous Page
Loading...
Need help?
General