Spectra 1759ex - Supervision Options for Wireless

SPECTRA 1759EX 19
PART 6: WIRELESS FEATURES
The Spectra 1759EX allows for the addition of up to eight fully supervised Omnia wireless transmitters, and up to eight programmable
remote controls.
6.1 WIRELESS TRANSMITTER PROGRAMMING
The programming of the wireless transmitters (detectors and door contacts) is accomplished in two steps:
1. Assign the wireless transmitter to the Spectra 1759EX.
2. Program the zones.
6.1.1 ASSIGNING WIRELESS TRANSMITTERS TO THE RECEIVER
Sections [601] to [608]
Sections [601] to [608] represent expansion inputs 1 to 8 respectively. For example, section [601] is assigned to
expansion input 1, section [602] is assigned to expansion input 2, etc. (refer to Table 6). Each Expansion Input
represents a specific zone in the Spectra 1759EX system (see Table 4 on page 13).
Do not assign detection devices from different modules to the same expansion input. For example, do
not assign a wireless transmitter to section [601] and then connect a detection device to input Z1 of the
APR3-ZX8.
The serial number is located on the inside of the transmitter or you can use the Serial Number Display (see
page 20) to determine its serial number.
The transmitters must be activated once having been assigned to the Spectra 1759EX. To activate a
transmitter, insert the batteries and close the cover. To ensure proper synchronization between the control
panel and the transmitter, open and close the zone corresponding to the transmitter.
6.1.2 DELETING ASSIGNED WIRELESS TRANSMITTERS
Sections [601] to [608]
6.1.3 PROGRAMMING THE ZONES
The zones allocated to the wireless transmitters must be programmed. Refer to Zone Programming on page 13 for
more information.
6.2 VIEWING THE WIRELESS TRANSMITTER SIGNAL STRENGTH
Sections [631] to [638]
Once wireless transmitters have been installed and assigned to the Spectra 1759EX, the signal strength of each transmitter can
be verified in sections [631] to [638]. Each section represents the signal strength viewer for a specific device. For example,
Table 6: Sections and Expansion Inputs
Section # 6-digit Serial Number Expansion Input
[601] ___/___/___/___/___/___ Input 1
[602] ___/___/___/___/___/___ Input 2
[603] ___/___/___/___/___/___ Input 3
[604] ___/___/___/___/___/___ Input 4
[605] ___/___/___/___/___/___ Input 5
[606] ___/___/___/___/___/___ Input 6
[607] ___/___/___/___/___/___ Input 7
[608] ___/___/___/___/___/___ Input 8
How Do I Assign Wireless Transmitters to the Spectra 1759EX?
1) Press the [ENTER] key.
2) Enter your [INSTALLER CODE].
3) Enter the desired [SECTION NUMBER] (from sections [601] to [608]).
4) Enter the 6-digit [
SERIAL NUMBER] of the wireless transmitter.
How Do I Delete Assigned Wireless Transmitters?
1) Press the [ENTER] key.
2) Enter your [
INSTALLER CODE].
3) Enter the desired [
SECTION NUMBER] (from sections [601] to [608]).
4) Press the [0] key six times to clear the serial number.