6) While wearing a powder-free latex glove grab the new bulb and place it into the
contact probe clamp while moving the bulb pins to align them with the pins
sockets, shown in the picture below. CAUTION: even with latex gloves on be
careful not to touch the inside of the bulb’s reflector. The oils from your finger or
dust from the gloves can stick to the reflector and can alter its output
characteristics including service life.
7) Lightly press the bulb into the receptacle after the pins and sockets are aligned.
There should be a slight click to indicate the bulb is properly seated in the
receptacle.
To Next Page
Loading...