What to do if no sensor appears on the display of Spectrum Technologies Fieldscout TDR 350 Measuring Instruments?
If no sensor appears on the display of your Spectrum Technologies Measuring Instruments, the sensor cable might be dirty or unplugged. To resolve this, clean the cable connection, check the cable connection to the display, and confirm that the probe block is securely plugged into the display.
How to fix unable to save data or load firmware from USB flash drive on Spectrum Technologies Fieldscout TDR 350?
If you are unable to save data or load firmware from a USB flash drive on your Spectrum Technologies Measuring Instruments, confirm that the drive is not full, verify the drive has FAT or FAT32 format, and ensure the firmware is in the root directory, outside of any folders.
What to do if my Spectrum Technologies Measuring Instruments device is unable to save data or load firmware from a USB flash drive?
If your Spectrum Technologies Measuring Instruments device is unable to save data or load firmware from a USB drive, first ensure that the USB drive isn't full. Also, verify that the USB drive is formatted with FAT or FAT32. For firmware loading issues, confirm that the firmware file is located in the root directory of the USB drive.
General| Brand | Spectrum Technologies |
|---|---|
| Model | Fieldscout TDR 350 |
| Category | Measuring Instruments |
| Language | English |
Controls device power and screen navigation.
Used to enter menus and confirm selections.
Navigates menus up and deletes data.
Navigates menus down and takes readings.
Guide on initial configuration and probe attachment.
Step-by-step instructions for obtaining soil measurements.
Initial screen displaying firmware version.
Shows measurements, rod type, soil type, and count.
Configure rod length, soil type, and temperature units.
Manage data logs and clear averages.
Configure backlight, GNSS, Bluetooth, and sound.
Enables or disables geo-referencing of measurements.
Manages power consumption for geo-referencing.
Integrates QZSS satellite system for location data.
Instructions for setting device date and time manually or via satellite.
Explains how internal maps improve location accuracy over time.
Steps to detach display from sensor base.
Guide for installing new batteries.
Procedure to remove the display module.
Instructions for saving data to USB.
Steps to clear logged data from the meter.
Defines VWC and related soil moisture levels.
Explains the TDR technology for VWC measurement.
Explains EC measurement and its relation to VWC.
Defines and explains the Salinity Index.
Adds accurate temperature reading capability.
Aids in positioning for specific soil depths.
Tool for pre-drilling holes in hard soil.
Checks sensor readings in various conditions.
Addresses issues with USB data transfer.
Troubleshooting steps for sensor connection errors.
States compliance with directives and standards.
To Next Page
