Spectrum SP-UV 200 Series User Manual

1. Unpack the contents carefully and check the materials.
2. Place the i
nstruments in suitable location.
3. Remove any obstructions or materials that could hinder the flow of air under and around the instrument
vibration.
4. Select the right voltage.
5. Plug the power cord into an outlet. Turn on the instrument and allow it to warm up for 20 minutes before
taking any readings. A self-test starts automatically.
Your spectrophotometer is now ready for operation.
6.3 Select light source
You can select light source switch point between 325nm to 355nm.
1. Press [Function]. (Press again, if necessary, to display lamp Exchange menu item).
2. Press [4], to select lamp Exchange menu item. Press [Enter].
3. Use [0] ~ [9] to set light source switch point. Press [Enter].
6.4 Turn the Lamps on/off
You can turn off halogen lamp or the deuterium lamp, when your methods do not need it.
1. Press [Function]. (Press again, if necessary, to display Lamp on/off menu item).
2. Press [5], to select Lamp on/off menu item. Press [Enter].
3. Press [1], to turn on tungsten lamp. Press [2], to turn off tungsten lamp. Press [3], to turn on
deuterium lamp. Press [4], to turn off deuterium.
User’s Manual SP-UV 200 11
Spectrum Instruments

Spectrum SP-UV 200 Series Specifications

General

Brand	Spectrum
Model	SP-UV 200 Series
Category	Measuring Instruments
Language	English