Spectrum SP-UV 200 Series User Manual

1 Introduction
The SP-UV 200 is a single beam spectrophotometer. The instrument is compact, easy-to-use, and
ruggedness. The large sample compartment can accept various accessories and cell from 10mm to 100mm
path length. The built-in RS-232 serial interface enables the instrument to be connected to a printer.
The SP-UV 200 is ideal to use in a clinical laboratory, biochemical laboratory, petrochemical laboratory,
environmental protection and various fields of quality control. This user’s manual provides the description of
the SP-UV 200, a list of main specifications and available accessories.
After carefully unpacking the content, check the materials against the packing list to ensure that you
have received everything in good condition. If some parts are missing, damaged or have any other defects,
please contact you dealer or the sales representative immediately.
1.1 Warning and safety labels on SP-UV 200
The following warning and safety labels are located on the SP-UV 200:
Caution! Hazardous area. Do not remove this cover under any circumstances. Trained
service peoples only. No serviceable components inside. Select the right voltage.
Disconnect the power cable before opening the device cover or replacing fuses!
User’s Manual SP-UV 200 4
Spectrum Instruments

Spectrum SP-UV 200 Series Specifications

General

Brand	Spectrum
Model	SP-UV 200 Series
Category	Measuring Instruments
Language	English