03
2.3 Suction Bracket Installation
1.Align the suction bracket clips with the holes on the back of the
device and push them up to secure the bracket.
2.Thoroughly clean and dry the car dashboard surface, remove
dust or debris, and make sure the surface is flat.
3. Tear off the protective film on the suction cup bracket, firmly
place the suction cup in the center of the dashboard, and then
press the lock button.
4.Adjust the angle of the device screen.
Note
The installation position of equipment and brackets should not
block the driver's sight and affect driving safety.
2.4 Dash Bracket Installation
1. Thoroughly clean and dry the surface of the car dashboard,
removing any dust or debris and ensuring a smooth surface.
2. Peel off the protective film from the bottom adhesive of the
device bracket.
3. Stick the device onto the appropriate position on the dashboard.
4. Press down on the bottom bracket of the device to ensure a
secure adhesive bond.
5. Adjust the device screen to the desired angle.
Note
The installation position of equipment should not block the driver's
sight and affect driving safety.
To Next Page
Loading...
