Spektrum DX3R User Manual

EN
22 SPEKTRUM DX3R PRO USER GUIDE
dx3r Pro TroubleshooTIng guIde
Problem
Possible Cause Solution
•Thesystemwillnot
connect
•Yourtransmitterandreceiveraretooclose
together. They should be 1 to 4 feet apart.
•Youarearoundmetalobjects.
•Yourtransmitterwasaccidentallyputinto
bind mode and is not bound to your receiver
anymore.
•Movetransmitter1to4feetfromreceiver.
•Movetoanareawithlessmetal.
•Rebindyourtransmitterandreceiver.
•Thereceivergoesinto
failsafe mode a short
distance away from the
transmitter
•Checkthereceiverantennatobesureitisnot
cut or damaged.
•ReplaceSR3100antenna(SPM9005)orcontact
Horizon Product Support
•Makesureyourantennaisinanantennatube
and up in the air as high as possible
•Receiverquitsresponding
during operation
•Inadequatebatteryvoltage
•Looseordamagedwiresorconnections
between battery and receiver
•Chargebatteries.Spektrumreceiversrequire
at least 3.5V to operate. An inadequate power
supply can allow voltage to momentarily drop
below 3.5V and cause the receiver to brown out
and reconnect.
•Checkthewiresandconnectionbetweenbattery
and receiver. Repair or replace wires and/or
connectors
general noTes
As the user of this product, you are solely responsible
for operating it in a manner that does not endanger
yourself and others or result in damage to the product
or the property of others.
Carefully follow the directions and warnings for
this and any optional support equipment (chargers,
rechargeable battery packs, etc.) that you use.
Safety Points to Obey for Modelers
• Ensureyourbatteries(bothtransmitterandreceiver)
have been properly charged for your model.
• Keeptrackofthetimethesystemisturnedonso
you will know how long you can safely operate the
transmitter.
• Checkallservosandtheirconnectionspriorto
each run.
• Donotoperateyourmodelnearspectators,parking
areas or any other area that could result in injury to
people or damage of property.
• Donotoperateyourmodelduringadverseweather
conditions. Poor visibility can cause disorientation and
loss of control of your model.
• Donotpointthetransmitterantennadirectlytowardthe
model. The radiation pattern from the tip of the antenna
is inherently low.
• Donottakechances.Ifatanytimeduringtheoperation
of your model you observe any erratic or abnormal
operation, immediately stop operation of your model
until the cause of the problem has been ascertained
and corrected. Safety can never be taken lightly.
sd Card
The DX3R PRO features an SD card reader allowing
your transmitter’s software to be updated by an SD
card (sold separately). Simply download the software
(when available) from the Spektrum website and
follow the instructions to load it onto your SD card.
To upload the new software to your DX3R PRO:
•Removethegrip
•InserttheSDcard
•Turnonyourtransmitter
•Waitforafewsecondsuntilthemain screen is
displayed.
•RemovetheSDcard
•Replacethegrip
The transmitter is updated and ready for use.

Spektrum DX3R Specifications

General

Brand	Spektrum
Model	DX3R
Category	Remote Control
Language	English