uX MANUAL 14 118151-001 REV A
Chapter 5
OPTIONS
He options available for this power supply are
described in this section. Interface diagrams are
shown where required. Options are specified by
including the option code in the model number as
described in Section 1.5.
5.1 XRM Compatible Cable XCC
The XCC option allows the uX power supply to except
the same high voltage output cable that is used on the
XRM series power supply.
5.2 5 Volt Programming and
Monitor 5VPM
5VPM changes the voltage and current programming
inputs and monitors to 0-5V = 0-full rated output.
5.3 Grid Bias Option GB
Plug-n-play compatibility for Oxfords Apogee X-ray
tubes that utilize grid bias control.
5.4 Mammoflex HV Cable K5302
Mammoflex HV cable for uX.
5.5 Mammoflex HV Cable K2001
Mammoflex HV cable for uX with XCC option.
5.6 Custom Designed Models
X(#)
Units built to customer specifications are assigned an X
number by the factory. If this unit is an X model, a
specification control sheet is added at the end of this
instruction manual.
Spellman welcomes the opportunity to tailor units to fit
your requirements or to develop new products for your
applications. Contact Spellman Sales Department with
your needs.
T
To Next Page
Loading...
