IM-IBR17-49IN Issue 14
Cast Iron is a brittle material. If the product is dropped
during installation and there is any risk of damage the
product should not be used unless it is fully inspected and
pressure tested by the manufacturer.
Safe Handling
1.13 Residual hazards
In normal use the external surface of the product may be very hot. If used at the
maximum permitted operating conditions the surface temperature of some products
may reach temperatures in excess of 300 °C (572 °F).
Many products are not self-draining. Take due care when dismantling or removing
the product from an installation (refer to 'Maintenance instructions').
1.14 Freezing
Provision must be made to protect products which are not self-draining against
frost damage in environments where they may be exposed to temperatures below
freezing point.
1.15 Disposal
Unless otherwise stated in the Installation and Maintenance Instructions, this
product is recyclable and no ecological hazard is anticipated with its disposal
providing due care is taken.
v1.16 Returning products
Customers and stockists are reminded that under EC Health, Safety and Environment
Law, when returning products to Spirax Sarco they must provide information on
any hazards and the precautions to be taken due to contamination residues or
mechanical damage which may present a health, safety or environmental risk. This
information must be provided in writing including Health and Safety data sheets
relating to any substances identified as hazardous or potentially hazardous.
1.17 Working safely with cast iron products on steam
Cast iron products are commonly found on steam
and condensate systems. If installed correctly using
good steam engineering practices, it is perfectly
safe. However, because of its mechanical properties,
it is less forgiving compared to other materials such
as SG iron or carbon steel. The following are the
good engineering practices required to prevent
waterhammer and ensure safe working conditions
on a steam system.
To Next Page
Loading...
Need help?
General
