IM-P402-130 EMM Issue 9
2
1. Safety information
Safe operation of this product can only be guaranteed if it is properly installed,
commissioned, used and maintained by qualified personnel (see Section 1.11) in
compliance with the operating instructions. General installation and safety
instructions for pipeline and plant construction, as well as the proper use of tools
and safety equipment must also be complied with.
Your attention is drawn to IEE Regulations (BS 7671, EN 12953, EN 12952 and
EN 50156). Elsewhere, other regulations will normally apply.
All wiring materials and methods shall comply with relevant EN and IEC standards
where applicable.
Warning
This product is designed and constructed to withstand the forces encountered during
normal use. Use of the product other than as a boiler controller, or failure to install
the product in accordance with these Instructions, product modifications or repair
could:
-
Cause injury or fatality to personnel.
-
Cause damage to the product / property.
-
Invalidate the marking.
These instructions must be stored in a safe place near the product installation at all
times.
Warning
This product complies with Electromagnetic Compatibility Directive 2014/30/EU and
all its requirements.
This product is suitable for Class A Environments (e.g. industrial). A fully detailed
EMC assessment has been made and has the reference number:
-
UK Supply BH LC2250 2012.
The product may be exposed to interference above the limits of heavy Industrial
Immunity if:
-
The product or its wiring is located near a radio transmitter.
-
Excessive electrical noise occurs on the mains supply. Power line protectors (ac)
should be installed if mains supply noise is likely. Protectors can combine
filtering, suppression, surge and spike arrestors.
-
Cellular telephones and mobile radios may cause interference if used within
approximately 1 metre (39") of the product or its wiring. The actual separation
distance necessary will vary according to the surroundings of the installation
and the power of the transmitter.
This product complies with Low Voltage Directive 2014/35/EU by meeting the
standards of:
-
EN 61010-1:2010 Safety requirements for electrical equipment for measurement,
control, and laboratory use.
This product has been type tested as a level control by meeting the standard:
-
VdTÜV requirements for water level control and limiting devices, water level
100 (2010).
IM-P402-130 EMM Issue 9
To Next Page
Loading...
Need help?
General
