Spirax Sarco PLC - Non-Password Protected Parameter Setup; Pressure Controller Action Configuration

30 3.635.5275.253
Conguration
1. Parameters non protected by a password
Actions of the pressure controller
To set the controller actions proceed as follows:
Step 1 – Access Screen 5 (operation mode selection). Press the
^
e
^
keys to select the item “PARAMETERS”.
Pressing then the OK key Screen 26 will be displayed:
Screen 26
Enter the desired value of the proportional band (gain) constant (0 to100%) using the
^
- and +
^
keys.
Note: the entered value will be stored until a successive modication.
Step 2 – Press the
^
key to access next screen.