Spirax Sarco PLC - Integral Action Constant Setup; Power Reset Constant Setup

313.635.5275.253
Enter the desired value of the integral action constant (0 to 10) using the
^
- and +
^
keys.
Note: the entered value will be stored until a successive modication.
For values set near to “0” or to “10” this action will be fast or slow respectively.
Step 3 – Press the
^
key to access next screen.
In case of control with only the proportional band action, enter the desired value of the power reset constant
(0 to 100%) using the
^
- and +
^
keys.
Note: the entered value will be stored until a successive modication.
This setting is only possible when the constant of the integral action is forced to “0”.
Screen 27
Screen 28