353.635.5275.253
Screen 34
To enter the pressure value:
Press the OK key twice.
The preset value of the full scale will blink.
Press the
^
o
^
keys to enter the desired value in the blinking digit.
Press the OK key to set the zero scale. Its value will be addressed. In order to modify it (normally 204) press
the
^
o
^
keys to increase or decrease its value for each digit and use the
^
- and +
^
keys to move into
digit positions for units, tenths and hundreds.
Press the OK key when terminated.
To enter the value 1019 of full scale use the
^
- and +
^
keys.
Press then
^
key.
Using the
^
- and +
^
keys move into the digit positions still to be set.
Press the
^
o
^
keys to enter each desired value.
Upon termination of this setting press in sequence the OK and ESC keys and nally the
^
key.
To enter the pressure/level value:
Press the OK key twice.
The digit of the full scale value in decimal will blink.
Press the
^
o
^
keys to enter the desired value.
Press then the
^
key and move the cursor on the digit with the value in units.
The value in units of the full scale will blink.
Press the
^
o
^
keys to enter the desired value.
Press the OK key upon termination of the setting.
The following screen 34 is displayed:
To Next Page
Loading...
Need help?
General
