What to do if Spirax Sarco SP7-10 display ERROR 23?
If the Spirax Sarco Valve Positioners display ERROR 23, it indicates an error when verifying the checksum of the configuration data (RAM). If the error persists even after the positioner has been reset, the device will need to be returned to the manufacturer for repair.
What to do if Spirax Sarco SP7-10 Valve Positioners display ERROR 22?
If the Spirax Sarco Valve Positioners display ERROR 22, it indicates an error during the table processing, pointing to an error in the working data (RAM). If the error persists even after the positioner has been reset, the device will need to be returned to the manufacturer for repair.
What to do if Spirax Sarco SP7-10 Valve Positioners display ERROR 21?
If the Spirax Sarco Valve Positioners display ERROR 21, it indicates an error while processing the measured values, pointing to an error in the working data (RAM). If the error persists even after the positioner has been reset, the device will need to be returned to the manufacturer for repair.
How to reset the stroke counter on Spirax Sarco SP7-10 Valve Positioners (ALARM 6)?
To reset the counter on Spirax Sarco Valve Positioners after ALARM 6, you need to use a connected PC with suitable software.
What does ALARM 4 mean on Spirax Sarco SP7-10 Valve Positioners?
ALARM 4 on Spirax Sarco Valve Positioners indicates that controlling is inactive because the device does not operate in control mode or the binary input is active. To resolve this, switch to control mode or switch off the binary input.
What to do if Spirax Sarco SP7-10 show ERROR 20?
If your Spirax Sarco Valve Positioners display ERROR 20, it indicates that there is no access possible to the data in the EEPROM. If resetting the device doesn't restore access, load the factory settings. If the error persists, the device must be returned for repair to the manufacturer.
What causes ALARM 1 on Spirax Sarco Valve Positioners?
ALARM 1 on Spirax Sarco Valve Positioners is caused by leakage between the positioner and the actuator. To address this, check the piping.
What to do if Spirax Sarco Valve Positioners display ALARM 3?
If the Spirax Sarco Valve Positioners are showing ALARM 3, it means there is an alarm from the zero monitor, indicating that the zero position has shifted by more than 4%. To solve this, correct the mounting.
What to do if Spirax Sarco SP7-10 Valve Positioners display ERROR 12?
If your Spirax Sarco Valve Positioners are displaying ERROR 12, it indicates that the position is outside the measuring range, possibly due to a malfunction in the position sensor. Check the mounting to resolve this issue.
How to fix ERROR 13 on Spirax Sarco SP7-10 Valve Positioners?
ERROR 13 on Spirax Sarco Valve Positioners indicates an invalid input current, which occurs when the setpoint signal is overridden. To resolve this, check the power source and the wiring.
General| Enclosure Rating | IP66 / NEMA 4X |
|---|---|
| Input Signal | 4-20 mA DC |
| Supply Pressure | 1.4 to 7 bar (20 to 100 psi) |
| Weight | 1.5 kg (3.3 lbs) |
| Materials | Internal parts: Stainless steel, brass, and plastic |
| Ambient Temperature Range | -20°C to +70°C (-4 to +158°F) |
To Next Page
