Spirent C1 - Admin Command Interface for Network Settings

Spirent C1 and C2 Installation Instructions
Connecting to the SPT-C1 and SPT-C2
Spirent C1 and C2 Installation Instructions | 25
PN 71-008959 Rev A April 2020
Whichever method you use to connect to the appliance, you will be prompted to log in
when the appliance is fully booted up. Use the following system administrator login /
password:
• Login: admin
• Password: spt_admin
Spirent TestCenter - Spirent Communications, Inc.
Device : 192.168.0.100 255.255.255.0 (static)
Gateway : 192.168.0.1
Welcome admin.
Type help for a list of commands
admin(hypervisor)>>
You can now use the following commands to set the addressing mode and/or set the IP
address, netmask and gateway. When you have made your changes, you must activate the
new settings and reboot the appliance:
admin(hypervisor)>> mode - shows the current IP addressing
mode.
admin(hypervisor)>> mode dhcp - sets the IP addressing mode to
DHCP.
admin(hypervisor)>>mode static - sets the IP addressing mode to
static.
Note: You must manually set the IP address, netmask and gateway, if you use the static
setting.
admin(hypervisor)>> ipaddress - shows the current IP address.
admin(hypervisor)>> ipaddress 192.168.1.10 - sets the IP
address.
admin(hypervisor)>> netmask - shows the current netmask.
admin(hypervisor)>> netmask 255.255.255.0 - sets the netmask.
admin(hypervisor)>> gwaddress - shows the current gateway
address.
admin(hypervisor)>> gwaddress 192.168.1.1 - set the gateway
address.
admin(hypervisor)>>activate - Activates your new settings