14 English User manual - 1.0
7.2 Failure table
7.3 Rotate the dry pocket (for units
with a rotatable magnetic dirt
separator)
1. Loosen the ring nut (A).
2. Rotate the complete dry pocket (B) to the desired
position.
3. Tighten the ring nut to the correct torque. Refer to
section 3.5.1.
8GUARANTEE
8.1 Terms of guarantee
• The guarantee for Spirotech products is valid until 5
years following the purchasing date.
• The guarantee may be rendered invalid in cases of
faulty installation, incompetent use and/or non-
authorised personnel trying to make repairs.
• Consequencial damage or losses due to failures are
not covered by the guarantee.
• Normal wear and tear are excluded from the
guarantee.
Problem Possible cause Correction
Automatic air vent drips at first use
(not applicable for BE/HE or BF/ HF)
Normal at first use No problem
Leakage at automatic air vent (not
applicable for BE/HE or BF/ HF)
The deaeration cap is worn or
damaged
Replace the deaeration cap.
Leakage at the dry pocket (only for
BE...M/BC...M/XC..M)
The dry pocket or O-ring is damaged Replace the dry pocket or O-ring.
Refer to the the dry pocket
replacement manual.
Handle of the dry pocket is not in the
closed position (only for BE...M/
BC...M/XC..M)
The dry pocket is damaged Replace the dry pocket. Refer to the
the dry pocket replacement manual.
NOTE
It is only possible to rotate the magnetic dirt
seperator when the unit is empty and not
under pressure.
NOTE
A few turns is enough. It is not necessary to
completely unscrew the ring nut of the dry
pocket.
NOTE
It is possible to rotate the dry pocket 360°.
To Next Page
