Tsupport@itwcp.co.uk
www.itwcp.co.uk
Technical Helpline UK: 0800 731 4924
Technical Helpline ROI: 1 800 882 388
Pulsa Operator Guide
Use
The PULSA 700 can be used in all positions:
Wall CeilingFloor
Carefully read the safety precautions on page 11
before use.
Place the pin guide against the base material
• the fan is on,
• the green light is not flashing,
• the gas is injected into the combustion chamber then
mixed with air by the fan.
Pull the trigger
• the gas / air mixture burns,
• the fan keeps operating for approx 10 seconds
To avoid overheating, do not hold the device by the
upper hood during use. This obstructs the filters.
When the cycle is over, the tool is ready for another
sequence. When finished, remove the battery or place it in
safe position.
Suitable base materials:
Concrete / Pre-
cast concrete
Rendered hollow
block;
Hollow floor block
Solid / rendered
brick
Steel
Use
The PULSA 700 can be used in all positions:
Wall CeilingFloor
Carefully read the safety precautions on page 11
before use.
Place the pin guide against the base material
• the fan is on,
• the green light is not flashing,
• the gas is injected into the combustion chamber then
mixed with air by the fan.
Pull the trigger
• the gas / air mixture burns,
• the fan keeps operating for approx 10 seconds
To avoid overheating, do not hold the device by the
upper hood during use. This obstructs the filters.
When the cycle is over, the tool is ready for another
sequence. When finished, remove the battery or place it in
safe position.
Suitable base materials:
Concrete / Pre-
cast concrete
Rendered hollow
block;
Hollow floor block
Solid / rendered
brick
Steel