20
Programming Direct Access memory buttons
It is possible to program the two-touch memories, but the memory protect switch
located underneath the memory index card must be set to the opposite position
and returned to the normal position when programming is complete.
The programming operation should be performed with extreme care as it may
result in unprogramming of the one-touch buttons.
To store a Direct Access memory; Press the button. “STORE” will appear
on the display.
Press one of the Direct Access memory buttons 11, where you wish the memory
to be stored.
At the prompt dial the number to be stored. It is possible to store the Handsfree
function as the first character. In this case when a memory button is
pressed, the telephone will automatically seize the line and make the call, in
Handsfree mode.
Press the button
- at “ENTER NAME” prompt key in the name to be stored using the numeric
keypad press the appropriate button a number of times to display the letter you
require. Press the to move the cursor to the next space use the buttons
to edit the name or buttons to edit the number
Press the button
“STORE COMPLETED” will appear on the display.
If you make a mistake in entering the data, simply overwrite the memory data by
doing the entry again.
To Next Page
Loading...
