- Unscrew the security knob in the direction of
the arrow (threading on left), then pull out the
mixing unit, the bell shaped seal and the bowl
gasket on the back (Рис.31).
- Remove the drip tray by pulling it outward
(Рис.32).
- Thoroughly wash all the removed components
with hot water and dish washing, but do not use
abrasive detergents or powders that can
damage the bowl.
I
M
P
O
R
T
AN
T
Do not use too
aggressive sanitizers o
r
detergents,
these kind of
products cou
l
d
damage the bowl and the
o
t
h
e
r
co
m
pon
e
n
t
s
.
C
A
UT
I
O
N
Never
perform
these
washing o
pe
r
a
t
i
on
with a dish
washing
m
a
ch
i
n
e
;
failure
to
d
o
so could
seriously
damage the unit’s
pa
rt
s
.
- Rinse well and then place all the components
in the sanitizer solution; for proper sanitizing
the parts must remain fully plunged for 15
minutes or as recommended by the sanitizer
manufacturer.
- After respecting the correct sanitizing period,
rinse well all the components with clean water
and dry them up with a clean cloth.
- Thoroughly wash the evaporator and the drip
tray surfaces with a sponge soaked with the
sanitizer (see Рис.33).
- Repeat all these operations with a clean
sponge soaked with water and carefully dry up
Рис. 31
Рис. 32
Рис. 33
To Next Page
Loading...
