Once performed all these cleaning and sanitizing
procedures, it’s possible to reassemble all the
components.
The correct assembly of the device is
essential
to prevent leakage of product and damage
of
the machine. To assemble the machine you
will
need an approved lubricant (such as
Vaseline).
Make sure all parts have been washed
and
sanitized before assembling. Persons
assembling
the machine must first wash and sanitize
their
hands and forearms with an approved sanitizer.
- Spread Vaseline on the bell shaped seal
internal surface before reassembling it
(Рис.34).
Рис.
34
- Reassemble the rear gasket and the bell
shaped one, respecting the correct direction as
indicated in Рисure 35.
- Reassemble the mixing unit making sure that
the frontal cylinder perfectly fit inside its
rotating shaft seat.
- Block all these components into place by
turning the knob in counter clockwise direction
(Рис.36).
Рис. 35
Рис.
36
To Next Page
Loading...
