SprayTECH EPX2155 User Manual (English)

Questions and Answers:

C
Cheryl JordanAug 4, 2025
What to do if my SprayTECH Water Pump will not run?
- T
  Tracy JimenezAug 4, 2025
  If your SprayTECH Water Pump isn't running, first, ensure it's properly plugged in. Check the breaker and reset it if it has tripped. If the pressure control knob is at the minimum setting, turn it clockwise to increase the pressure setting and supply power to the unit. Inspect for faulty or loose wiring, and if found, take it to a SprayTECH authorized service center. Finally, give the motor time to cool down.
J
jrubioAug 11, 2025
Why does my SprayTECH EPX2155 have a poor spray pattern?
- T
  Todd SotoAug 11, 2025
  A poor spray pattern from your SprayTECH Water Pump can stem from several causes. The spray tip may be worn or too large, so replace it following the spray gun instructions. Excessive pressure can also be the culprit; decrease spray pressure by rotating the pressure control knob counterclockwise. If the spray tip is too large for the material, replace it with a new or smaller one. Adjust the pressure by rotating the pressure control knob for a proper spray pattern. Ensure sufficient fluid delivery by cleaning all screens and filters. Lastly, if the material is too viscous, add solvent according to the manufacturer's recommendations.
S
sheilasmithAug 17, 2025
Why does my SprayTECH EPX2155 lack power?
- K
  kelsey89Aug 18, 2025
  If your SprayTECH Water Pump lacks power, it could be due to a low pressure adjustment. Rotate the pressure control knob clockwise to increase the pressure setting. Also, check the voltage supply and reconnect the input voltage for 120V AC if necessary.