UNLOCKING THE SIDE PANEL CAP
1. To unlock, turn the cap anti-clockwise
2. Lif the cap to detach
LOCKING THE SIDE PANEL CAP
1. Place the cap over the input panel
2. Turn the cap clockwise until tight*
*Nomad Alpha is only dust and waterproof when this cap is
properly closed.
CHARGING YOUR NOMAD ALPHA
1. Switch of the main power switch
2. Connect the speaker via the USB-C input to
a power source* using the included USB-A to
USB-C cable
3. Blue LEDs indicate the power level of charge**
*Power source options include USB connection to
a Sprout AC power adapter, a Sprout car charger or
computer/notebook USB connection.
**Full charge will take about 8-10 hours.
Please refer to LED indicator section in this product manual.
CONNECTING VIA 3.5MM AUX CABLE
To play audio using the aux cable, connect the cable
from the Nomad Alpha to your device.
Please note: Using 3.5mm aux input will override a
Bluetooth source input.
CONNECTING VIA BLUETOOTH
1. Switch on the main power switch
2. Press the power buton for approximately three
seconds. The LED indicator will flash blue/red to
indicate Nomad Alpha is ready for pairing*
3. Turn on Bluetooth on your mobile phone/music
device**
4. ‘Nomad Alpha’ will appear on your mobile phone/
music device. Select ‘Nomad Alpha’ to pair
5. Once your mobile phone/music device is
connected to Nomad Alpha, you will hear
‘Bluetooth connected’***
6. Enjoy your music
*If the LED indicator is not flashing red and blue, hold the
UNISYNC buton for 5 seconds to initiate Bluetooth pairing.
**If you are not familiar with Bluetooth pairing for your mobile
phone/music device, refer to the user guide for your mobile
phone/music device for instructions to pair a new device
using Bluetooth.
***Nomad Alpha will always store the last device paired and
if the device is within Bluetooth range, Nomad Alpha will
automatically connect to the device.
3. QUICK START GUIDE 3. QUICK START GUIDE
54
To Next Page
Loading...
