SPRT SP-RMT12 - 3.3 Printer Configuration Settings

time. Then loosen the
【
FEED
】
button and the current setting and status will be
printed out.
3.2.4 Paper Feeding (Manual Feeding)
When the printer works normally, hold down
【
FEED
】
button, the paper
feeding begins, and stops when stopped holding the
【
FEED
】
button. When the
printer works in black mark mode, hold down
【
FEED
】
button, the printer
begins to feed paper and stops at the position of black mark. If the paper is not
black mark paper, the printer stops automatically after feeding paper for 30cm.
3.2.5 Battery Charging
After the printer has been in use for a period of time, the printer's battery power
will be exhausted. When the printer's battery power is nearly exhausted, if
there is printed data in the printer, the printer will give a power alarm by turning
the power indicator red. There will be three beeps; if the printer is in sleep state,
the printer will automatically turn off the power after three beeps, and the user
needs to charge the printer.
The charging method is as follows: insert the mains plug of the power adapter
into a 220V, 50Hz power socket, and then insert the charging plug into the
printer's power socket,
The printer will start charging. During the charging process, the POWER light
on the printer will turn red. When the battery is fully charged, the POWER light
on the printer will turn green. The time required for charging is about 3 hours.
During the charging process, if you use the printer to print the data, the
charging time will be extended.
3.3 Printer Setting
Users can set more parameters by using the attached software with printer
〈
Setting Tools
〉
through computer. The setting includes:Printer serial Baud
rate and data format, black mark, language, font, printing density, Bluetooth
device name and password etc. The setting method please refer to the <
Setting Tools Software Help>, offered with the software together.
3.4 Printer Interface Connection and Printing