Operators manual MODEL 80XX Planter
page 76 of 173
Maintenance
Hydraulic system
Periodic maintenance:
-Visual inspection for leads.
-Check level
Maintenance at the end of the harvesting season:
-Change oil as instructed
Changing the oil and checking the level:
Clean the area around the filling nozzle thoroughly before filling the system with new oil.
-Drain the old oil from the tank through the drain plug.
-Collect waste oil and dispose of ii in accordance with the statutory regulations on environmental
protection.
-Refit the drain plug after all the oil has been drained.
-Fill up through the filter plug with the required quantity of new oil to the correct specification.
-Check the level.
See the following figure for further information on changing the oil.
Electrical system
Always disconnect the power supply prior to carrying out any work on the
electrical system.
Only use original fuses. The use of fuses with a higher rating will cause
irreparable damage to the electrics.
To Next Page
Loading...
