Need help?Do you have a question about the Spudnik 8080 and is the answer not in the manual?
Specifies requirements for personnel operating, maintaining, or repairing the machine.
Provides specific safety guidelines for hitching, transporting, and operating towed equipment.
Outlines safety precautions and procedures for working with the high-pressure hydraulic system.
Details adjustable settings for row spacing on the planter.
Details adjustable settings for seed spacing on the planter.
Explains how to adjust planting depth using the gage wheel.
Describes adjustments for covering discs' angle, depth, and width.
Explains the function of the cup belt shaker and how it prevents dual allocations.
Details how to adjust the intensity of the vibration movement using levers and star wheels.
Describes the electrically driven high-intensity shaker and its adjustment.
Details how to set the feed chain speed using the flow control needle valve.
Explains how to set the seed bin level using the sensor bracket and adjusting screw.
Details how to adjust the frequency of the electrical and hydraulic shaker options.
Explains how to adjust shaker position for effective seed distribution based on conditions.
Details how seed depth is controlled and adjusted on the planter.
Describes adjustments for covering discs' down pressure, angle, and assembly.
Explains how seed spacing is set on mechanical and hydraulic drive planters.
Details how to achieve accurate seed spacing by controlling seed roll with adjustable wings.
Explains the function of the working position sensor for turning off row units during turns.
Explains the purpose and operation of each button on the CP600 control box interface.
Details settings related to the skip detection alarm, reload, and beep time.
Explains how to turn individual feed chains on/off and view chain status.
Covers settings for maximum chain on time, pause time, and buzzer alarm duration.
Procedure for setting the fertilizer value and calibration parameters.
Details suggested shaft speed for calibration and desired rotations for accurate settings.
Instructions on how to start the calibration process using buttons A and B.
Explains how the system calculates density and manual entry requirements.
Steps to confirm that the correct calibration has been set using 'OK' status.
Explains how seed spacing is measured using wheel speed or radar speed.
Details how to enter an offset for wheel or radar speed due to slippage or tire size.
Explains how to access and modify hydraulic drive system parameters via the 'SERVICE' menu.
Details setting the run speed, slowest speed, and fastest speed for row unit seed cups.
Guide to accessing and modifying fertilizer hydraulic drive system parameters.
Details setting the run speed, slowest speed, and fastest speed for fertilizer box valves.
Covers setting the start value and proportional value for fertilizer hydraulic drive control.
Shows how to view the status of skip detection and feed chain operation for each row.
Displays the operational status of fertilizer valves and the dry fertilizer box encoder.
Monitors the status of the chemical box clutch and hydraulic motor operation.
Lists essential safety precautions to be observed during maintenance, cleaning, and repair work.
Details periodic maintenance, filter changes, and oil level checks for the hydraulic system.
Identifies and illustrates all parts constituting the planter's row unit.
General| Brand | Spudnik |
|---|---|
| Model | 8080 |
| Category | Farm Equipment |
| Language | English |
To Next Page
