Operators manual MODEL 80XX Planter
page 68 of 173
Maintenance
Storage
Only carry out adjustments and maintenance work when the engine is
switched off!
Remove ignition key!
Secure the machine against rolling away!
Secure machine against rolling away!
Engage parking brake and use wheel chocks!
Careful storage of the machine or the spare parts avoids repair costs and downtimes. At the same
time, reliability and service life are improved
Make a note of all maintenance work to be carried out before the next season and arrange for this to
be carried out in good time.
Your SPUDNIK dealer is in a better position to perform maintenance work and any repairs that may be
necessary outside the season.
The instruction below should be followed at the end of the harvesting season:
Storage instructions See section for further
information
Clean the machine thoroughly. Dirt attracts moisture and leads to
corrosion.
Cleaning the machine
Store the machine in a dry place. Do not store in the vicinity of artificial
fertilizers (mineral).
---
Clean all drive chains thoroughly and spray them with chain spray in
order to prevent corrosion.
Chain drive
Smear grease on all unpainted parts, the piston rods of all hydraulic
cylinders and the threads of all spindles.
---
Check moving parts (hinges etc.) for ease of movement, dismantle if
necessary, clean and check for signs of wear. Replace with new parts if
necessary.
---
Grease the machine thoroughly. Lubrication
Repair paint defects, protect any bare metal with a good coating to rust
inhibitor.
---
Follow the instructions for engine storage in the case of self-propelled
machines.
---
To Next Page
