Operators manual MODEL 80XX Planter
page 10 of 173
General safety and accident prevention regulations
The safety advice and information given in this operating manual, the valid nation regulations
concerning accident prevention and any applicable internal employment, operational and safety
regulations of the operator are to be observed.
1. Warning signs and other notices on the machine provide important information for safe
operation. Observing them will serve your safety.
2. Before starting work, make yourself familiar with all the equipment and controls as well
as their functions. To do so when you have already started work is too late!
3. The user should wear close-fitting clothing. Avoid loose-fitting clothing!
4. Keep the machine clean to avoid the risk of fire!
5. Check around the machine before moving off or starting up (watch out for children)!
Make sure you have adequate all-around visibility.
6. Always match your speed to the local conditions! Avoid sudden turning maneuvers when
driving uphill or downhill or when traveling across a slope!
7. Observe the respective regulations when using public roads!
8. Take into account the wide overhang and/or the sideways force acting on the machine
when turning or negotiation curves!
9. Only start up the machine when all guards are attached and in their correct (protective)
position!
10. Stay clear of the turning and pivoting areas of the machine!
Non-observance of the safety and accident prevention regulations entails the
following risks:
-Endangering the operator or other nearby persons as a result of safety devices not being
fitted or being in their correct (protective) position!
-Damaging important machine functions!
-Errors when carrying out maintenance or repair work!
-Endangering the operator or other nearby persons through certain mechanical or
chemical peculiarities!
-Risk of pollution due to leaks in the hydraulic system, fuel tank, pipes, as well as in the
engine and gearbox!
To Next Page
Loading...
