Operators manual MODEL 80XX Planter
page 33 of 173
Feed Chain Functions
The Feed Chains may be switched on or off individually. This allows you to leave a path to the center
tower of pivots.
Rows may have the feed chain
turned off in order to leave a path to
the center tower of the pivot.
Note: The feed chain is the device that is turned on or off. This means that the belt with the
seed cups will continue to plant seed until the hopper it pulls from is empty. Therefore, the
feed chain must be turned off in time so that the cups will not have seed by the time you
reach your desired destination.
1
2
3
5
6
7
8
4
9
10
CP600 CONTROL BOX
To Next Page
Loading...
