Operators manual MODEL 80XX Planter
page 72 of 173
Maintenance
Tires
Repair work to the wheels may only be carried out by an
authorized dealer.
Only work on the wheels when the engine is switched off!
Remove ignition key!
Secure the machine against rolling away!
Maintain the prescribed tire pressures and measure once a week (see technical specifications)
Check tire pressure daily (for 11.2-24/4 16 PLY tire – 54 P.S.I.)
(for 12.5L-16 PLY support wheel – 56 P.S.I.)
(for 18/8.50-8/4 gage wheel – 22 P.S.I.)
(for 11-1/4 x 24 diamond tread tire – 40 P.S.I.)
There is a risk of bursting if the tire pressures are too high!
Stand clear of the tires when pumping them up.
Check tire pressures regularly.
Tires with divided rim: Release tire pressure before attempting repairs!
When working on the wheels, secure the machine against rolling away (wheel chocks)!
Never work on machine which is supported only by a jack.
Make sure that the jack has adequate load-carrying capacity.
To Next Page
Loading...
