To Next PageTo Next Page
Need help?Do you have a question about the SPX Hankinson HHS-90 and is the answer not in the manual?
General| Model | HHS-90 |
|---|---|
| Nominal Capacity | 90 scfm |
| Capacity | 90 scfm |
| Operating Pressure | 100 psig |
| Inlet Temperature | 100°F |
| Pressure Dew Point | -40°F |
| Dew Point | -40°F |
| Purge Air | 15% |
| Maximum Pressure | 150 psi |
| Power Supply | 115V/1Ph/60Hz |
Safety precautions for pressure-containing equipment.
Electrical safety requirements and installation guidelines.
Specifies standard and optional maximum operating pressures.
Specifies minimum operating pressures for different MOP models.
Explains front panel LEDs, switches, alarms, timing, and sequences.
Describes the five operating modes of the Level 2 controller.
Describes how the controller displays alarms, service, and operational info.
Specific alarm messages and instructions for filter, desiccant, valve service.
Explains Display Mode information and Test Mode procedures.
Step-by-step guide for starting up the dryer and setting parameters.
Procedures for pressurizing the dryer and turning on power.
How to determine and adjust the purge rate for optimal performance.
Details purge pressure adjustment for different model series.
List of checks for power, moisture, pressure, and alarms.
Verifying operation within pressure, temperature, and ambient limits.
Information, frequency, and steps for desiccant replacement.
