To Next PageTo Next PageWhy is there a high pressure drop across my SPX HANKISON HIT 25 Dehumidifier?
A high pressure drop across your SPX Dehumidifier can be caused by: * A clogged inlet air strainer: Clean the inlet air strainer. * Excessive air flow: Check the flow rate. * A clogged separator filter: Replace the filter sleeve.
What to do if the refrigeration system is not functioning properly on my SPX Dehumidifier?
If the refrigeration system of your SPX Dehumidifier isn't functioning properly, it could be due to: * Power failure: Check the power to the unit. * Open line disconnect switch: Close the disconnect switch. * Blown fuses or open breaker: Check for continuity. * Faulty wiring or loose terminals: Have an electrician check the electrical connections. * High or low ambient conditions: Check the minimum/maximum temperature ranges. * Clogged ambient air filter: Clean the ambient air filter. * Clogged condenser fins: Clean the condenser. * Fan motor or fan control switch malfunction: Replace the fan motor or fan control switch. * Low voltage: Check the wiring.
General| Brand | SPX |
|---|---|
| Model | HANKISON HIT 25 |
| Category | Dehumidifier |
| Language | English |
Safety precautions for devices under pressure.
Electrical safety guidelines for equipment operation.
Information regarding air quality for breathing applications.
Guidelines for selecting an appropriate installation location.
Instructions for connecting compressed air piping.
Procedures for making electrical connections.
Step-by-step instructions for starting the dryer.
Guidance on replacing the separator/filter element.
Steps for servicing and replacing the automatic condensate drain.
