Why is there a high pressure drop across my SPX HANKISON HIT 50?
A high pressure drop across your SPX Dehumidifier can be caused by: * A clogged inlet air strainer: Clean the inlet air strainer. * Excessive air flow: Check the flow rate. * A clogged separator filter: Replace the filter sleeve.
What to do if the refrigeration system is not functioning properly on my SPX HANKISON HIT 50?
If the refrigeration system of your SPX Dehumidifier isn't functioning properly, it could be due to: * Power failure: Check the power to the unit. * Open line disconnect switch: Close the disconnect switch. * Blown fuses or open breaker: Check for continuity. * Faulty wiring or loose terminals: Have an electrician check the electrical connections. * High or low ambient conditions: Check the minimum/maximum temperature ranges. * Clogged ambient air filter: Clean the ambient air filter. * Clogged condenser fins: Clean the condenser. * Fan motor or fan control switch malfunction: Replace the fan motor or fan control switch. * Low voltage: Check the wiring.
What to do if there is water downstream of my SPX HANKISON HIT 50 Dehumidifier?
If there's water downstream of your SPX Dehumidifier, it could be due to several reasons: * Residual moisture in downstream pipelines: Blow out the system with dry air. * Open air bypass system: Check the valve positions. * Reversed inlet and outlet connections: Ensure correct connections. * Low temperatures around downstream air lines: Insulate or heat trace air lines exposed to low ambients, or use dry air to lower the dew point. * Excessive moisture at the dryer inlet: Install a separator ahead of the dryer. * Condensate not draining automatically: Replace the drain mechanism if it's not working. * Restricted or frozen drain line: Open the drain line. * Dryer overload: Check the inlet air temperature, pressure, flow rate (compressor capacity), and ambient air temperatur...
Safety precautions for equipment operating under pressure.
Instructions for safe electrical installation and operation.
Guidance on choosing an appropriate installation site.
Detailed steps for initiating the dryer's operation.
Causes and solutions for moisture in output air.
Identifying and resolving increased pressure loss.
Interpreting and rectifying alarm indicators.
Troubleshooting compressor cycling and system failures.
Details on coverage duration and warranty conditions.
General| Brand | SPX |
|---|---|
| Model | HANKISON HIT 50 |
| Category | Dehumidifier |
| Language | English |
To Next Page