SPX Power Team PE17 Series User Manual

HYDRAULIC PUMP
Max. Capacity: See Pump Data Plate
Definition: A hydraulic pump delivers hydraulic fluid under
pressure through the use of compressed air, an electric motor,
or a gas engine as a power source.
Form No. 102875
Operating Instructions for:
Electric Motor Powered Pumps
Gas Engine Powered Pumps
Rotary Air Motor Powered Pumps
(As listed in EC Declaration)
dB(A) at
Idle and
Pump kw 700 Bar
PE8 Series .37 67/81
PE17 Series .37 67/81
PA17 Series 1.12 85/90
PE30 Series .74 87/82
PG30 Series 1.49 84/96
PE46 Series 1.12 77/81
PA46 Series 2.24 85/90
PE55 Series .84 87/86
PA55 Series 2.24 87/88
PG55 Series 2.98 75/87
PR10 Series .19 65/72
PG18 Series 1.86 81/96
PG120 Series 4.1 85/95
PQ120 Series 2.24 73/78
PG400 Series 14.9 N/A
66262 2.24 N/A
UNIVERSAL
MOTOR
TEFC MOTOR
AIR MOTOR
DC MOTOR
RESERVOIR
GASOLINE
ENGINE
NOTE:
• For a detailed parts list or to locate a Power Team Authorized
Hydraulic Service Center, contact your nearest Power Team facility.
A list of all Power Team facilities is located at the end of this
document.
•
Carefully inspect the pump upon arrival. The carrier, not the
manufacturer, is responsible for any damage resulting from
shipment.
• The customer can choose from a variety of motors, controls,
reservoirs, and other options. These instructions will include
directions for options that your particular pump may not have.
• Do not change motors without consulting the pump manufacturer's
Technical Services Department.
QUARTER HORSE
®
12 VDC
Sheet No. 1 of 8
Rev 10 Date: 02 Mar 2005
© 2005 SPX Corporation
Tech. Services: (800) 477-8326
Fax: (800) 765-8326
Order Entry: (800) 541-1418
Fax: (800) 288-7031
SPX Corporation
5885 11th Street
Rockford, IL 61109-3699 USA
Internet Address:
http://www.powerteam.com
®

SPX Power Team PE17 Series Specifications

General

Brand	SPX
Model	Power Team PE17 Series
Category	Water Pump
Language	English

Summary

Safety Definitions and Precautions

Safety Definitions

Explains safety symbols like DANGER, WARNING, and DANGEROUS VOLTAGE used in the manual.

General Safety Precautions

Essential safety rules for operating, maintaining, and handling hydraulic equipment to prevent injury.

Hydraulic System Setup Instructions

Filling Pump Reservoir and Bladder

Procedure for filling the hydraulic fluid reservoir or bladder and initial setup.

Hydraulic Connections and System Bleeding

Steps for connecting hydraulic lines and removing air from the system.

Electric Pump Operation Guide

Electric Pump Operating Procedures

Gas and Air Pump Operation

Gasoline Engine Pump Operation

Air Motor Pump Operation

Directional Control Valve Options

2-Way Valve for Single-Acting Cylinders

3-Way Valve for Single-Acting Cylinders

Pressure Regulating Control Adjustments

Adjusting the Pressure Regulating Valve

Procedure to set and adjust the pressure regulating valve for desired system pressure.

Adjusting the Pressure Switch

Steps to set the pressure switch for automatic pump shutdown at a specific pressure.

Preventive Maintenance Procedures

Hydraulic Fluid Maintenance

Component Cleaning and Lubrication

Maintenance, Draining, and Troubleshooting Intro

Draining and Cleaning Reservoir and Bladder

Troubleshooting Guide Introduction and Warnings

Troubleshooting: Pump and Cylinder Issues

Pump Fluid Delivery and Pressure Problems

Diagnosing issues with low fluid delivery, pressure loss, and maintaining pressure.

Cylinder Operation and Pressure Maintenance

Troubleshooting cylinder extension/retraction and pump pressure build-up.

Troubleshooting and Support Information

Pump Pressure and Cylinder Retraction Issues