SPXFLOW Colloid Mill - Flush Water Seal Replacement

13
95-03028
09/2019
Waukesha Cherry-Burrell
®
Brand Colloid Mill Maintenance
1. Disassemble as described in “Disassembly” on page 10.
2. Remove the four body nuts (Figure 22).
3. Slide the body forward o󰀨 the shaft (Figure 23).
4. Pull the seal out with a hook tool. Insert a new water lip seal
with the lip facing in. (See item 18 in Figure 29 on page 15.)
5. Re-assemble in reverse order.
Flush Water Seal
Replacement
Figure 22 - Remove body nuts (4)
Figure 23 - Remove body
Figure 24 - Replace lip seal
Lip seal