Battery Instructions
General : The SPY
®
battery is a completely sealed, rechargeable
12 volt unit. It can be used in any position and under
most conditions.
To Charge The Battery :
Slide the charger onto the battery as far as possible. The
charger will have an amber LED on while charging. This
LED will be green when charged. A discharged battery
requires 4-8 hours to fully charge.
There is no danger of overcharging the battery. After
the battery is fully charged, the charger will maintain a
trickle charge to keep the battery at peak charge.
It is recommended that the battery be recharged as soon
as possible after use.
Do not disconnect the charge power cord while the battery
is attached.
Battery Storage:
The battery should be fully charged BEFORE storing.
Storage at temperatures below 75˚F is recommended.
After six months of storage or storage in extremely high
temperatures, the battery should be recharged to maintain
peak efficiency and maximize its life span.
This Portable Holiday Detector is an accurate, reliable
instrument which is only warranted if it is properly handled,
maintained and operated as prescribed by Pipeline
Inspection Co., Ltd.
BATTERY REMOVAL:
Press the release (orange part) on
the base plate (black part) and push
the battery away from the rear handle.