Spyder MR6 - How to Clean the Marker; Squeegee Cleaning of Barrel and Breach; Disassemble Rear Internals

HOW TO CLEAN THE MARKER
DANGER: Do not look down the Marker barrel. Always wear goggles specically designed for paintball use
while working on your paintball Marker.
IMPORTANT: Always have the Marker on SAFE MODE before disassembly. Remove all paintballs and air
source from the Marker before performing any maintenance.
HELPFUL TIP: Follow these steps to help clean/remove Marker parts should in the event of a paintball break.
SQUEEGEE CLEANING OF THE BARREL AND BREACH
Using a Stick Squeegee (not included)
If the Venturi Bolt is in the un-cocked position you need to re-cock the Marker. Slide a stick squeegee down
the barrel until it reaches the Markers breach. Then remove the stick squeegee out of the barrel. This should
wipe clean any paint residue that could have broken inside the Marker. HELPFUL TIP: Make sure the Markers
breach is clean and clear of any paintball shell fragments or dirt. Repeat this step if the paint residue did not
wipe clean after the rst attempt.
Using a Pull Squeegee (not included)
Twist off the barrel and slide a Pull Squeegee squeegee from the threaded end so the swab is the last portion
of the squeegee out of the barrel tip. Grab hold the tail of the cable squeegee and pull. This should wipe clean
any paint residue that could have broken in the barrel. HELPFUL TIP: Make sure the Markers breach is clean
and clear of any paintball shell fragments or dirt. Repeat this step if the paint residue did not wipe clean after
the rst attempt.
DISASSEMBLE / REASSEMBLE REAR INTERNALS
DISASSEMBLE REAR INTERNALS
HELPFUL TIP: The Stock should not be attached to the Receiver when removing Rear Internals.
STEP 1. Pull out the Disconnect Pin from the Receiver. HELPFUL TIP: Remove the Striker Plug while the
marker in the un-cocked position this will prevent the internals from springing out because the Striker Spring
is compressed.
STEP 2. Remove the Striker Plug with the Striker Spring and Striker Buffer out the back of the Receiver.
STEP 3. Tilt the back of the marker into your hands ready catch the Venturi Bolt and Striker Bolt from the back
of the Receiver. HELPFUL TIP: When the internals are removed it would be wise to clean any dirt or paint from
the inside of the Receiver with a squeegee and wipe the Venturi Bolt clean with a rag or paper towel. Apply
some paintball gun oil on Striker O-ring periodically. IMPORTANT: It is not necessary to disassemble the rear
internals for basic maintenance unless the Striker O-ring needs to be replaced.
Receiver (1)
Venturi Bolt (4)
Bolt Pin (3)
Quick Disconnect Pin (61)
Striker Bolt (56)
Striker Buer (57)
Striker Spring (58)
Velocity Adjuster (59)
Striker Plug (62)
7